Victron Smart BatteryProtect - 100AMP - 6-35 VDC - Bluetooth Capable

Meet the Victron Smart BatteryProtect 100A, a versatile protection device for 12/24V systems. It guards against deep discharge, doubles as a reliable on/off switch, and offers Bluetooth-enabled programming for quick, field-ready setup.

• Current rating: 100 A continuous protection for critical loads.
• Voltage range & auto-ranging: 6–35 VDC with automatic detection for 12/24V systems (voltage detected once).
• Bluetooth programming: Bluetooth enables engaging/disengaging level adjustment; nine predefined levels via the programming pin; Bluetooth can be disabled if you prefer fixed settings.
• On/off input: Use the dedicated input to switch system power for quick, reliable control.
• Li-ion compatibility: Special Li-ion mode supports VE.Bus BMS control and can function as a charging interrupter between charger and Li-ion battery.
• Ultra-low current draw: Designed to minimize standby consumption, especially important for Li-ion systems after a low voltage shutdown.
• Over-voltage protection: Disconnects the load if voltage exceeds 16.3 V (32.6 V in higher voltage configurations) to protect sensitive loads.
• Ignition protection: MOSFET-based switching eliminates sparks—no relays.
• Delay & alarm behavior: Alarm activates if voltage stays below the disconnect threshold for more than 12 seconds; the load disconnects 90 seconds after dropping below the threshold, and reconnects 30 seconds after voltage rises above the reconnect level.
• Compatibility & modes: 12/24V auto-ranging with a dedicated Li-ion setting; can also function as a charger interrupter for Li-ion batteries.

This device helps prevent battery damage from deep discharge, reduces the risk of a no-start scenario, and simplifies power management with a reliable, programmable protective interface. It provides clear separation between essential and non-essential loads, keeping your system safe and ready when you need it.